Baby Lock Aurora

• This does not identify an industrial/commercial needle-system code or authorize unlisted needle products.

Use home sewing machine needles in the documented size range of 65/9 through 100/16.

• Match the exact fabric row, thread and needle using the complete table, trial sew first, and never use thread of 20 weight or lower; inappropriate combinations may cause injury or malfunction.

Use 65/9-75/11 with 60-90 weight polyester or 50-80 weight cotton/silk for lightweight fabrics; 75/11-90/14 with 60-90 weight polyester or 50-60 weight cotton/silk for medium fabrics. For heavyweight fabric, the table pairs 100/16 with 30 weight polyester/cotton in its first row, and 90/14-100/16 with 60 weight polyester or 30-50 weight cotton/silk in its broader second row. Use ballpoint 75/11-90/14 with 50 weight thread for stretch fabrics, and a 75/11 home sewing needle for embroidery.

• This is exact BLMAR evidence and does not establish unrestricted Class 15 or cross-brand interchangeability.

The manual identifies OEM part X52800-120 as a Class 15 type bobbin.

• No substitute part number or cross-brand equivalence is established.

Use the supplied plastic bobbin or the same type, identified as X52800-120.

• Height and material are incomplete compatibility specifications and remain bound to X52800-120 or the same-type restriction; diameter and full geometry remain unknown.

The specified bobbin is plastic and 11.5 mm (approximately 7/16 inch) high.

• Follow the source order and use the correct foot for the selected stitch. This proves the source-native pin/notch mechanism, not a standardized low-shank class or universal-foot fit.

The documented foot snaps onto the holder: raise the needle, lock the controls, raise the presser-foot lever, press the holder's black release button, align the foot pin with the holder notch, lower the lever until the pin snaps into the notch, raise the lever to verify attachment, then unlock the controls.

• Loosen the screw to remove the holder; the procedure does not instruct removing the screw itself. The source-specific holder procedure does not establish holder dimensions, generic screw-on feet or adapter compatibility.

For a foot that does not use the holder, lock the controls, remove the foot, loosen the holder screw counterclockwise and remove the holder. To reattach it, raise the lever, align the holder notch with the screw, hold the holder in place, tighten the screw clockwise and securely fasten it before unlocking the controls.

• No universal, third-party, cross-brand or standardized-shank compatibility is asserted.

Use presser feet designed specifically for this machine and the correct foot for the selected stitch.

• Only exact accepted Aurora BLMAR and this retained Baby Lock August2025 accessory catalog; other names, suffixes, generations and regions remain separate.
• This is a manufacturer chart classification, not dimensions, a universal adapter/holder promise, an offered retail unit, supplied equipment or proof that every accessory in the group fits. Follow exact manual and accessory conditions.
• Keep the printed G/L code: G is the accessory group; L uses the existing evidence engine low-shank mapping. No measured shank height, interchangeable holder or generic foot fit is established.

Low shank (the OEM group/shank chart prints G/L).