Brother SE2000

• Use the exact fabric/thread/needle table and sew trial stitches on the actual layers. The reviewed source does not establish a standardized needle-system code.

Use home sewing machine needles; the manual says needle and thread selection depends on fabric type and thickness.

• This is an explicit manual span, not permission to use every size for every material. Follow the table's fabric/thread combinations and trial-stitch guidance.

The manual states an overall home-sewing-needle span of 65/9 through 100/16, with the exact selection dependent on fabric type, thickness and thread; it separately recommends 75/11 for embroidery.

• Raise the needle, lock the controls, remove and reinstall the presser foot as directed, and never use a bent needle.

Insert a straight needle with its flat side toward the rear until it touches the needle stopper, then securely tighten the needle-clamp screw.

• Use the supplied plastic bobbin or bobbins of the same type. The Class 15 wording does not prove every marketed Class 15 bobbin is equivalent.

The manual identifies Brother SA156 as a Class 15 type bobbin.

• Height and material alone are not a universal substitution test; other bobbins can damage the machine.

The specified plastic bobbin or same type is 11.5 mm (approximately 7/16 inch) high.

• Lock all keys and operation buttons first and keep the bobbin held down while routing the thread. The source's bobbin symbol is only an orientation reference.

Insert the correctly wound bobbin so its thread unwinds left, hold it down, guide the thread around the cover tab and through the slit, cut the thread, and reattach the bobbin cover.

• Lock the controls, raise the needle and presser-foot lever, use the source-specified foot for the selected stitch, and confirm it is secure. This describes the documented attachment and does not establish universal foot compatibility.

Press the black rear button on the holder to release the installed foot. Align the replacement foot's pin with the holder notch and lower the lever until the pin snaps into the notch.

• Lock the controls and securely tighten the holder screw. The procedure does not identify a standardized shank class or prove third-party compatibility.

For a foot that does not use the holder, remove the foot, loosen the holder screw counterclockwise, and remove the holder. Reattach by aligning its notch with the screw and tighten clockwise while holding it in place.